Club Car Pioneer 900, Maintenance Service Manual, Page: 281 / 344

UNITIZED TRANSAXLE Unitized Transaxle Removal
2001 Pioneer 900 Gasoline Vehicle Maintenance and Service Manual Page 16-9
16
3.6. Disconnect the engine ground wire from the oil filler tube mounting bracket (Figure 16-14,
Page 16-9).
3.7. Loosen nuts securing shifter cable to shifter cable mounting bracket. Then disconnect the shifter
cable rod end from the shifter arm on the unitized transaxle and remove the cable from the cable
mounting bracket (Figure 16-15, Page 16-9).
3.8. Remove screws (2) securing the Forward/Reverse shifter cable bracket (1) to transaxle and
remove the shifter bracket (Figure 16-34, Page 16-15).
3.9. Loosen nut (3) and bolt (7) on transaxle shifter lever and remove lever from shaft (9) (Figure 16-
34, Page 16-15).
3.10. Remove woodruff key (10) from shifter shaft (9) (Figure 16-34, Page 16-15)
3.11. Mark for proper reconnection and then disconnect the 6 gauge white wire (F2 post), 6 gauge
black ground wire (A2 post), and 16 gauge yellow wire (DF post) from starter/generator (Figure
16-16, Page 16-9).
3.12. Disconnect the engine oil level sensor wire (18 gauge yellow) at the connector just to the rear of
the starter/generator) (Figure 16-17, Page 16-9).
Figure 16-14 Engine Ground Wire Figure 16-15 Shifter Cable
Figure 16-16 Generator Wires Figure 16-17 Oil Level Sensor Jumper Wire
Club Car
Remove engine ground
retaining nut.
TOP VIEW
Loosen nuts.
Pull spring release back to
remove shifter cable from lever.
DF
F2
Remove
6 gauge
white wire.
Remove 16 gauge
yellow wire.
Remove ground
wire at
A2 terminal.
STARTER
GENERATOR
YELLOW
OIL SENDING
UNIT JUMPER
WIRE