FE350 ENGINE
Cylinder Head
Page 13-10 2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual
13
ROCKER ARM AND PUSH ROD REMOVAL
NOTE: Because FE350 engines are equipped with hydraulic lifters, which automatically eliminate all clear-
ance in the valve train, the rocker arms (3) and the push rods (5) do not need to be put back in their
original positions (Figure 13-11, Page 13-10).
1. Remove the two bolts (1) and remove the rocker cover (2) along with the breather tube (3) (Figure 13-
2. Remove the E-ring (1) and pull the rocker shaft (2) out of the cylinder head (Figure 13-11, Page 13-10).
3. Lift out the rocker arms (3), washer (4), and push rods (5).
CYLINDER HEAD REMOVAL
1. Remove the six bolts (1) and take off the cylinder head assembly (2) (Figure 13-12, Page 13-11).
2. Remove head gasket (3). Note the position of the two dowels (4) as shown (Figure 13-13, Page 13-11).
Figure 13-8 Upper Shroud and Oil Filler Removal
Figure 13-9 Head Shroud Removal
Figure 13-10 Remove Rocker Cover
and Breather Tube
Figure 13-11 Remove Rocker Arms
and Push Rods
TYPICAL 4
PLACES
22
14
23
17
18
21
20
19
10
11
14
14
14
12
13
TYPICAL 5
PLACES
Club Car
3
1
2
1
2
3
4
5
