IQ DISPLAY MODULE (IQDM-P) SERIES 2 PROGRAMMING
Plugging the Handset into the Vehicle
Page 18-2
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement
18
PROGRAM MENU
The
program
menu can be accessed by pressing the right arrow on the navigation button when the square
beside
program
is blinking
. When the
program
menu is active, use the up or down arrows on
the navigation button to go to the desired item in the
program
menu. Again, press the right arrow to select the
menu item. Use the change value button to change the values of the selected item by pr or -.
The following parameters can be programmed with the handset from the
program
menu:
NOTE:
M1 refers to “Mode 1” and M2 refers to “Mode 2.” To activate Mode 2 in the IQDM-P Series 2, Code
A, Code B and Code C must be entered.
See Code A, Code B, and Code C on page 18-5.
All set-
tings in Mode 2 are programmed with the same procedues as Mode 1.
M1/M2 SPEED
The vehicle’s top speed can be changed by selecting values 1 through 4.
See chart below.
A vehicle programmed for speed setting 4 does not conform to ANSI Z130.1 – American National Standard for
Golf Cars – Safety and Performance Specifications because it is capable of speeds in excess of 15 mph (24.1
km/h). For more information on this feature, contact your local Club Car distributor or dealer.
SPEED SETTING
VEHICLE SPEED
1
8.0 mph (12.9 km/h)
2
12 mph (19.3 km/h)
3
15 mph (24.1 km/h)
4
17 mph (27.4 km/h)
Figure 18-2 Access Program Menu
2
3
Program
Monitor
Faults
Functions
Information
Programmer Setup
