Club Car IntelliTach Carryall 295, Owner'S Manual

Page: 14 / 72

Controls and Indicators
Page 12 2007 Carryall 295 Intellitach and XRT 1550 Intellitach Diesel Vehicle Owner’s Manual
KEY SWITCH
The key switch (3) is mounted on the instrument panel to the right of the steering column (Figure 4) . It has
four positions: PREHEAT, OFF, ON, and START.
Use the PREHEAT feature if the temperature falls below 23 °F (–5 °C). Do not hold the key in the PREHEAT
position longer than 20 seconds. To preheat glow plugs in cold weather, turn the key to the PREHEAT posi-
tion, and hold it there for 10-15 seconds. Then turn the key to the START position, and hold it there until the
engine starts. If the engine does not start after 10-15 seconds, turn the key to the OFF position and repeat the
procedure. Once the engine starts, release the key and it will return to the ON position. The engine will idle in
neutral. The engine will continue to idle until the key is turned to the OFF position.
See previous WARNING,
CAUTION and NOTE.
Turn the key to PREHEAT position if the temperature falls below 23 °F (–5 °C). Do not hold the key in the
PREHEAT position longer than 20 seconds.
ý
WARNING
• Moving parts! Keep clear of the engine compartment while the engine is running.
CAUT ION
• Do not shift the Forward/Reverse handle while the accelerator pedal is pressed. Shift the
handle only when the vehicle is at a complete stop and the engine is at idle. Failure to heed
this caution could result in damage to the transmission.
NOTE: The key can be removed only when the key switch is in the OFF position.
FORWARD/REVERSE CONTROL
The Forward/Reverse handle (1) is located on the right-hand side of the instrument panel. The handle has
three distinct positions: FORWARD (A), NEUTRAL (B), and REVERSE (C)
(Figure 4) . Push the handle up to
operate the vehicle in the forward direction, or pull the handle down to operate the vehicle in reverse. The
engine can be started only when the handle is in the NEUTRAL (middle) position. The engine must be at idle
before shifting the Forward/Reverse handle.
See WARNING and CAUTION on page 12.
Club Car vehicles operate at a reduced speed in reverse. The reverse buzzer will sound as a warning when
the Forward/Reverse handle is in the REVERSE position.
ACCELERATOR PEDAL
The accelerator pedal (4) is the pedal on the right (Figure 4) .
With the engine running and the Forward/Reverse handle in the FORWARD or REVERSE position, vehicle
speed will increase as the accelerator pedal is pressed. When the accelerator pedal is released, it will return
to the original position and the engine will idle.
See WARNING and CAUTION on page 12.
BRAKE PEDAL
The brake pedal (5) is located to the immediate left of the accelerator pedal (Figure 4) . To slow or stop the
vehicle, press the brake pedal.