Club Car FE 350, Maintenance And Service Supplement

Page: 74 / 280

11
Test Procedures TROUBLESHOOTING AND ELECTRICAL SYSTEM
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! ! COM 200nA
MAX
1000 ---
750V
FUSED
1
1. 20k Ohm Setting
468
Figure 11-30 Secondary Coil Test – In Vehicle Test
3. Using a multimeter set to 20k ohms, measure the resistance of the secondary coil and spark plug cap together.
3.1. Place the red (+) probe of the meter into the end of the spark plug cap that normally connects to the spark
plug and place the black (–) probe on a clean unpainted surface of the engine or frame (Figure 11-30,
Page 11-32) .
3.2. If the resistance is between 12.0k - 14.0k ohms, the secondary coil and spark plug cap are within acceptable
limits; proceed to step 6 on page 12-25. If the resistance is not between 12.0k - 14.0k ohms, the spark plug
cap and secondary coil must be tested independently from each other.
4. Test the spark plug cap separately from the secondary coil.
4.1. Remove the rubber gasket (1) on the plug cap (2) by rolling back the gasket onto the spark plug wire (3)
(Figure 11-31, Page 11-33) .
4.2. Remove the cap from the wire by turning the cap counterclockwise three or four revolutions while gently
pulling it off the wire (Figure 11-32, Page 11-33) .
Page 11-32 2009 FE 350 Maintenance and Service Supplement