Club Car FE 350, Maintenance And Service Supplement

Page: 209 / 280

S27 FE 350 FUEL SYSTEM Engine Control Linkage
16
1
2
3
539
Figure 16-6 Accelerator Rod
Accelerator Rod Installation and Adjustment
1. Before installing the accelerator rod, adjust accelerator pedal position. See Section 5 – Accelerator and Brake
Pedal Group in the appropriate maintenance and service manual.
2. Install the ball joint on the ball stud at the accelerator pedal (Figure 16-6, Page 16-7) .
3. Access the engine compartment.
4. Remove the electrical box screw and cover (Figure 16-7, Page 16-8) .
5. Adjust length of accelerator rod. With the ball joint jam nuts (3) loose (Figure 16-6, Page 16-7) , adjust the
length of the accelerator rod so the indicated cam edge is parallel with the electrical component box as shown
(Figure 16-7, Page 16-8) . See following CAUTION.
CAUTION
• Be sure that approximately an equal number of threads are exposed at each end of the accelerator rod.
6. Install the accelerator rod on the bell crank ball joint on the electrical component box (Figure 16-8, Page 16-8) .
See following CAUTION and NOTE.
CAUTION
• Inspect the limit switch inside the electrical box. If the limit switch lever is bent, replace the switch.
NOTE: Use the inside hole location, or hole closest to the bell crank shaft as shown (Figure 16-8, Page 16-8) .
2009 FE 350 Maintenance and Service Supplement Page 16-7