Club Car DS Villager 4, Maintenance And Service Manual

Page: 457 / 510

GASOLINE VEHICLE - CLUTCHES Driven Clutch
23
2961D
Figure 23-20 Driven Clutch Assembly
3. Place the end of the spring (6) into the hole in the moveable sheave (9).
4. Install the key (7) into the keyway of the fixed sheave shaft.
5. Holding the cam (8) in position for assembly on the shaft, install the other end of the spring into the center spring
hole of the cam. Rotate the cam until the keyway is aligned with the key on the fixed sheave, and then start the
cam onto the shaft approximately 1/4 to 3/8 in. (6.3 to 9.5 mm).
6. With the clutch loosely assembled, set the edge of the clutch body (9) on a clean, flat surface (Figure 23-21,
Page 23-17) .
Figure 23-21 Driven Clutch Tool - Assembly
7. Assemble the threaded bolt (10) through the washer (11) and thrust collar (12).
NOTE: It is very important that the bolt, washers, and thrust bearing assembly be assembled in the order described
and shown.
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual Page 23-17