Club Car DS Villager 4, Maintenance And Service Manual

Page: 447 / 510

GASOLINE VEHICLE - CLUTCHES Drive Clutch
23
2. Remove the drive clutch hub (5) (Figure 23-2, Page 23-4) :
2.1. Remove the three plugs (4) from the clutch puller attachment holes.
2.2. Thread the center bolt of the Drive Clutch Hub Puller (1) into clutch until the stop nut touches the clutch,
then back the bolt out one-half turn (Figure 23-6, Page 23-7) .
2.3. Thread the three small bolts of the puller into corresponding holes in the clutch. Tighten bolts evenly,
making sure the face of the puller plate is parallel to the face of the clutch (Figure 23-6, Page 23-7) .
2.4. Unscrew the puller center bolt out of the clutch to pull drive clutch hub off.
598
Figure 23-5 Mark Drive Clutch Hub
599
Figure 23-6 Remove Drive Clutch Hub
3. Remove the thrust washer (9) from the moveable sheave (13) (Figure 23-2, Page 23-4) .
4. Remove the drive buttons (3) by removing the screws (1), flat washers (2), and drive button take-up springs
(4) as shown
(Figure 23-7, Page 23-8) .
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual Page 23-7