Club Car DS Villager 4, Maintenance And Service Manual

Page: 417 / 510

GASOLINE VEHICLE - FUEL SYSTEM Engine Control Linkages
21
3. Adjustment:
3.1. Connect the diagnostic tool.
3.2. Loosen the jam nuts (7 and 11) and back off the throttle stop screws (8 and 12) several turns (Figure
21-5, Page 21-5) .
Figure 21-5 Governor Cable Adjustment
3.3. Rotate the governor arm (9) counterclockwise until it stops and hold in this position.
3.4. Adjust the governor cable jam nuts (10) until throttle position sensor is at 100% on the diagnostic tool.
Tighten the governor cable jam nuts to 36 in·lb (4.0 N·m).
3.5. Release the governor arm to return to “idle” position.
3.6. Adjust the gap (A) between governor arm and stop screw (8) to 0.055 in. (±0.039) (1.4 mm (±1)). Tighten
the jam nut (7) to 36 in·lb (4.0 N·m).
3.7. Rotate the governor arm counterclockwise.
3.8. Adjust the stop screw (12) until the throttle position sensor is between 75 - 80%. Tighten the jam nut
(11) to 36 in·lb (4.0 N·m).
3.9. Check engine RPM adjustment. See Engine RPM Adjustment.
ACCELERATOR CABLE
Accelerator Cable Removal
1. Disable the vehicle.
2. Disconnect the battery and spark plug wire.
3. Remove the P-clamps that secure the accelerator cable to the engine assembly.
4. At transaxle:
4.1. Unhook the spring fitting (1) of accelerator cable (2) from governor arm (3) (Figure 21-6, Page 21-6) .
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual Page 21-5