Club Car DS Villager 4, Maintenance And Service Manual

Page: 391 / 510

GASOLINE VEHICLE - ELECTRICAL
COMPONENTS Neutral Lockout Limit Switch
19
MULTI-PURPOSE BUZZER LIMIT SWITCH INSTALLATION
1. Install the multi-purpose buzzer limit switch (5) on the two bolts (Figure 19-25, Page 19-24) .
2. Install washers (4) and neutral lockout limit switch (3).
CAUTION
• Do not overtighten the nuts. If the nuts are over tightened, the limit switches could be damaged.
3. Install the washers (2) and nuts (1). Tighten the nuts to 4 in·lb (0.45 N·m).
4. Set the Forward/Neutral/Reverse control (FNR) to R.
5. Make sure that both limit switches actuate.
6. Connect the blue multi-purpose buzzer limit switch wire to the main harness red wire.
7. Connect the black multi-purpose buzzer limit switch wire to the main harness orange wire.
NOTE: The red multi-purpose buzzer limit switch wire is not connected.
8. Connect the battery and spark plug wire.
9. Set the FNR to R. Make sure that the multi-purpose buzzer operates.
NEUTRAL LOCKOUT LIMIT SWITCH
See General Warnings on page 1-2.
The neutral lockout limit switch is located on the back of the Forward/Neutral/Reverse control (FNR).
NEUTRAL LOCKOUT LIMIT SWITCH REMOVAL
1.
2. Disconnect the battery and spark plug wire.
3. Disconnect the wires from the neutral lockout limit switch (1) (Figure 19-26, Page 19-25) .
Figure 19-26 Neutral Lockout Limit Switch Removal
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual Page 19-25