Club Car DS Villager 4, Maintenance And Service Manual, Page: 248 / 510

13
Forward/Reverse Rocker Switch
ELECTRIC VEHICLE - ELECTRICAL
COMPONENTS
1
4
3
1
2
Figure 13-5 USB Port Removal Figure 13-6 USB Port Installation
USB PORT INSTALLATION
1. Put the USB port wires into the dash.
2. Push the USB port into the dash.
3. Connect the red instrument panel wire to the red USB port wire (1) (Figure 13-6, Page 13-4) .
4. Connect the black instrument panel wire to the black USB port wire (2).
5. Vehicles with a battery condition indicator: Connect the red USB wire (3) to the battery condition indicator
positive terminal. Connect the black USB wire (4) to the battery condition indicator negative terminal.
6. Vehicles without a battery condition indicator: Attach the extra wires (3)(4) to the instrument panel harness
with a plastic tie.
7. Install the instrument panel.
FORWARD/REVERSE ROCKER SWITCH
See General Warnings on page 1-2.
TESTING THE FORWARD/REVERSE ROCKER SWITCH
See Test Procedure 6 – Forward/Reverse Rocker Switch on page 12-18.
FORWARD/REVERSE ROCKER SWITCH REMOVAL
1. Disconnect the batteries and discharge the controller. See Disconnect the Batteries – Electric Vehicles
on page 1-4.
2. Remove two screws (2) that hold Forward/Reverse rocker switch housing (1) to the vehicle (Figure 13-7, Page
13-5) .
3. Remove the three wires from the rocker switch.
4. Press in on the locking tabs on each side of switch (3), and push switch out of housing.
Page 13-4 2020 Precedent,Villager 2 and 4 Maintenance and Service Manual