Club Car Carryall XRT 1550, Maintenance And Service Manual

Page: 99 / 432

STEERING AND FRONT SUSPENSION Front Suspension Components
7
WARNING
• Strain on the brake hose or the brake hose fittings can result in damage to the line or fittings and
cause a leak in the hydraulic system, diminished brake performance, or brake failure.
• If at any point in this procedure the hydraulic system is opened, the brakes must be bled after the
correct reinstallation of the brake components. Failure to bleed the brakes could result in decreased
braking performance due to air being trapped in the hydraulic system. Use only DOT 5 brake fluid. See
Bleeding the Hydraulic Brake System on page 6-15.
10. Remove brake disc from hub.
11. Remove the outer drag link ball joints from the upright assemblies (Figure 7-30, Page 7-15) .
2065
Figure 7-30 Drag Link Ball Joint
12. Remove the lower and upper ball joint locknuts.
13. Remove the lower ball joint from the upright (Figure 7-31, Page 7-15) . See NOTE and CAUTION below.
1897
Figure 7-31 Lower Ball Joint and Upright
1898
Figure 7-32 Upper Ball Joint and Upright
14. AWD only: Swing the lower A-arm down, and separate the upright and hub assembly from the half-shaft.
15. Remove the upper ball joint from the upright (Figure 7-32, Page 7-15) . See following NOTE and CAUTION.
NOTE: It may be necessary to use a ball joint removal tool to separate the ball joint stud from the upright.
2013 Carryall 295/XRT 1550 Maintenance and Service Manual Page 7-15