Club Car Carryall XRT 1550, Maintenance And Service Manual

Page: 69 / 432

HYDRAULIC AND PARK BRAKE SYSTEMS Brake Pads and Caliper
6
963
Figure 6-2 Front Caliper Banjo Bolt
2493
Figure 6-3 Rear Caliper Banjo Bolt
6. Remove the two socket-head slide-pin bolts securing the caliper to its mounting bracket (Figure 6-4, Page 6-7) .
7. Pull the caliper off the mounting bracket and remove the pads (Figure 6-5, Page 6-7) .
964
Figure 6-4 Caliper Slide-Pin Bolts
997
Figure 6-5 Brake Pads
BRAKE PAD AND CALIPER INSTALLATION
WARNING
• If at any point in this procedure the hydraulic system is opened, the brakes must be bled after the
correct reinstallation of the brake components. Failure to bleed the brakes could result in decreased
braking performance due to air being trapped in the hydraulic system. Use only DOT 5 brake fluid. See
Bleeding the Hydraulic Brake System on page 6-15.
1. Place and hold the brake pads in the caliper and install the caliper onto its mounting bracket (Figure 6-5, Page
6-7) . See following NOTE and WARNING.
NOTE: To help prevent noise, a silicone-based brake lubricant may be applied to the surfaces (on the back side of
the brake pads) that contact the caliper. A thin film may also be applied to the slide-pins. Always follow
lubricant manufacturer’s directions.
2013 Carryall 295/XRT 1550 Maintenance and Service Manual Page 6-7