Club Car Carryall 500, Maintenance And Service Manual

Page: 72 / 456

5
Pedal Group Adjustment – Electric Vehicles ACCELERATOR AND BRAKE PEDAL GROUP
PEDAL GROUP ADJUSTMENT – ELECTRIC VEHICLES
See General Warnings on page 1-1.
1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2. Adjust brake pedal height.
2.1. Chock wheels and release park brake. Lift rear of vehicle and place jack stands under the axle tubes
to support the vehicle.
2.2. To provide slack in the brake cables, loosen the equalizer retaining nuts (1) on the equalizer rod (2) (Figure
5-19, Page 5-16) .
1
3
2
4
1400-18100-10209
Figure 5-19 Loosen Rear Brake Equalizer Rod Nuts
2.3. Loosen the brake stop jam nut (31), then relieve pedal pressure on the stop by pushing down slightly on
the pedal. Next, adjust the brake stop bumper (22) up or down (Figure 5-20, Page 5-17) . Adjusting the
bumper upward decreases distance between pedal and floorboard. Adjusting the bumper downward
increases distance between pedal and floorboard. Proper brake pedal height is 6 inches (15.2 cm)
(Figure
5-21, Page 5-17) .
2.4. Tighten the jam nut (31) to 8 ft·lb (9.5 N·m) (Figure 5-20, Page 5-17) .
Page 5-16 2017 Carryall 500 and 700 Maintenance and Service Manual