Club Car Carryall 500, Maintenance And Service Manual

Page: 67 / 456

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group Adjustment – Gasoline Vehicles
5
1
3
2
4
Figure 5-9 Loosen Rear Brake Equalizer Rod Nuts
2.3. Loosen the brake stop jam nut (31), then relieve pedal pressure on the stop by pushing down slightly on
the pedal. Next, adjust the brake stop bumper (22) up or down (Figure 5-10, Page 5-11) . Adjusting the
bumper upward decreases distance between pedal and floorboard. Adjusting the bumper downward
increases distance between pedal and floorboard. Proper brake pedal height is 6 inches (15.2 cm)
(Figure
5-11, Page 5-11) .
2.4. Tighten the jam nut (31) to 8 ft·lb (9.5 N·m) (Figure 5-10, Page 5-11) .
22
31
PA
RK
ST
OP
1 2
3
4
5
6
7
8
9
10 11
12
Correct pedal position is 6 inches (15.2 cm) from floormat to back of
brake pedal.
Figure 5-10 Brake Pedal Height Adjustment Figure 5-11 Brake Pedal Height Measurement
3. Adjust brake pedal free play. See following NOTE.
NOTE: Brake pedal free play is the distance the brake pedal can be pressed before the brake actuator arm (at the
brake cluster) moves.
3.1. Measure perpendicularly from the floorboard to the back of the brake pedal, then press the brake pedal
and measure the distance that the pedal moves before all of the slack is taken out of the brake cables
(Figure 5-11, Page 5-11) .
2017 Carryall 500 and 700 Maintenance and Service Manual Page 5-11