Club Car Carryall 500, Maintenance And Service Manual

Page: 397 / 456

FUEL SYSTEM: GASOLINE VEHICLES Engine Control Linkages
23
ACCELERATOR CABLE
Accelerator Cable Removal
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Disconnect battery and spark plug wire(s). See Disconnecting the Battery-Gasoline Vehicles on page 1-5.
3. At transaxle:
3.1. Unhook spring fitting of accelerator cable (8) from governor arm (4) (Figure 23-8, Page 23-10) .
3.2. Unsnap accelerator cable (8) from FNR/accelerator cable bracket (9).
4. At electrical component box:
4.1. Remove electrical component box cover and loosen jam nuts (10) on side of electrical component box
(Figure 23-10, Page 23-11) .
4.2. Disconnect barrel fitting (11) of accelerator cable (8) from cam (12) in electrical component box and remove
accelerator cable (8) from vehicle.
8
12
11
10
3046
Figure 23-10 Accelerator Cable At Electrical Component
Box
Accelerator Cable Installation
1. At transaxle:
1.1. Hook spring fitting of accelerator cable (8) to governor arm (4) (Figure 23-8, Page 23-10) .
1.2. Snap accelerator cable (8) into FNR/accelerator cable bracket (9).
1.3. Push dust shield (13) onto end of cable housing.
2. At electrical component box:
2.1. Insert barrel fitting (11) of accelerator cable (8) into cam (12) in electrical component box (Figure 23-10,
Page 23-11) .
2.2. Separate jam nuts (10) on cable and place threaded end into slot of electrical component box. Tighten
jam nuts (10) finger-tight.
2.3. Before tightening the cable jam nuts (10), make sure the engine RPM adjustment is correct. See Engine
RPM Adjustment on page 23-13.
2.4. Install electrical component box cover and tighten screw to 18 in·lb (2.0 N·m).
3. Connect battery and spark plug wire(s). See Connecting the Battery-Gasoline Vehicles on page 1-5.
2017 Carryall 500 and 700 Maintenance and Service Manual Page 23-11