Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 434 / 596

22
Muffler GASOLINE VEHICLE - EXHAUST SYSTEM
MUFFLER INSTALLATION
1. Install the new exhaust gasket (7) on the exhaust port studs (Figure 22-2, Page 22-2) .
Figure 22-2 Muffler Installation
2. Put the muffler (2) into position on the engine.
3. Install the nuts (3), bolt (4), washer (5), and bolts (6). Tighten the hardware by hand.
4. Tighten the hardware in the following order:
4.1. Tighten the nuts (3) to 19 ft·lb (26 N·m).
4.2. Tighten the bolt (4) to 17 ft·lb (23 N·m).
4.3. Tighten the bolts (6) to 17 ft·lb (23 N·m).
5. If the oxygen sensor (1) was removed, install the oxygen sensor. See Oxygen Sensor Installation.
6. Connect the battery and spark plug wire.
7. Set the Forward/Neutral/Reverse control (FNR) to N.
8. Set the Maintenance/Operate switch to MAINTENANCE.
9. Put the chocks against the wheels.
DANGER
• Do not operate gasoline vehicle in an enclosed area without proper ventilation. The engine produces
carbon monoxide, which is an odorless, deadly poison.
10. Start the engine.
11. Check for exhaust leaks and correct engine operation. See following DANGER.
Page 22-2 2021 Carryall 300 Maintenance and Service Manual