Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 377 / 596

GASOLINE VEHICLE - ELECTRICAL
COMPONENTS Kill Limit Switch
19
KILL LIMIT SWITCH
KILL LIMIT SWITCH REMOVAL
1. Disconnect the battery and spark plug wire.
2. Remove the screw (1) (Figure 19-38) .
2948E
Figure 19-38 Kill Limit Switch
3. Remove the electrical component box cover (2).
4. Remove the two nuts (3) and washers (4).
5. Remove the accelerator pedal limit switch (5). Do not disconnect the wires attached to accelerator pedal limit
switch.
6. Disconnect the wires from the kill limit switch (6).
7. Remove the kill limit switch.
KILL LIMIT SWITCH INSTALLATION
1. Connect the white/black wire to the common (COM) terminal.
2. Connect the blue wire to the normally open (NO) terminal.
3. Install the kill limit switch (6) on the mounting screws (Figure 19-38, Page 19-31) .
4. Install the accelerator limit switch (5) on the mounting screws.
5. Install the two washers (4) and two nuts (3). Tighten the nuts to 5 in·lb (0.6 N·m). See following CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are overtightened, limit switches could be damaged.
6. Press and release the accelerator pedal to make sure that both switches are being activated when the pedal
is released.
2021 Carryall 300 Maintenance and Service Manual Page 19-31