Club Car Carryall 300 2021, Maintenance And Service Manual

Page: 143 / 596

CONTROLLER DIAGNOSTIC TOOL (CDT) Plugging the CDT into the Vehicle
11
PLUGGING THE CDT INTO THE VEHICLE
694
Figure 11-2 Communication Port Under Instrument Panel
1. Connect one end of the cable to the port located on the bottom of the CDT.
2. Connect the cable adaptor to the CDT cable.
3. Find the communication port on the vehicle (Figure 11-2, Page 11-3) .
4. Remove the dust cap from the communication port.
5. Align the keyed portion of the plug with the communication port and insert plug into port.
INTRODUCTORY DISPLAY
Immediately after the CDT is connected to the vehicle, it begins loading controller information. During this time, the
loading status is shown as a percentage, the CDT's software version is given, and status/information icons appear in
the upper right corner. Once loading is complete, the screen displays the Main Menu.
NOTE: If the Power button is used to turn ON the handset and the handset is not connected to a vehicle, the message
“No System Detected” will be displayed.
In the event that the handset does not display any information, or the screen is difficult to read, refer to the CDT
troubleshooting procedures.
See CDT Troubleshooting on page 11-26.
2021 Carryall 300 Maintenance and Service Manual Page 11-3