Club Car CARRYALL 272, Maintenance And Service Manual

Page: 269 / 312

MC012C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK Unitized Transaxle Removal
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual Page 16-13
16
13. Carefully lift the snubber out of the snubber bracket in the vehicle frame and lower it to the floor
(Figure 16-29, Page 16-13) . The powertrain should be completely disconnected from the vehicle and
resting on the floor.
14. Grasp the ends of the leaf springs at the rear of the powertrain and roll the powertrain out from under the
vehicle (Figure 16-30, Page 16-13) .
15. Place blocks under the engine pan so they will completely support the engine and keep it level to the floor
(Figure 16-31, Page 16-14) . See following NOTE.
NOTE: Place the blocks so they will support the engine when the transaxle is detached and moved away
from the engine.
16. Remove the drive belt.
16.1. Grasp belt midway between drive and driven clutch and pull up on belt to force the driven clutch
sheaves apart. Roll the belt counterclockwise while pulling it off driven clutch (Figure 16-32,
Page 16-14) .
Figure 16-27 Spring Retainer Bolts Figure 16-28 Rear Shackles
Figure 16-29 Snubber Figure 16-30 Remove Powertrain
REMOVE BOLTS, THEN
ROTATE SHACKLES
UP AND AWAY
FROM SPRINGS.
SNUBBER BRACKET
SNUBBER