Club Car CARRYALL 272, Maintenance And Service Manual

Page: 233 / 312

FUEL SYSTEM Engine Control Linkage
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual Page 14-9
14
Accelerator Cable Installation
1. Connect the accelerator cable (7) to the cam in the electrical box (Figure 14-8, Page 14-11) .
2. Insert the cable housing into the mounting slot in the wall of the electrical box, with approximately the
same number of threads visible between the jam nuts as are visible from the nut inside the box to the end
of the cable housing
(Figure 14-5, Page 14-8) . Tighten the nuts finger-tight.
3. Connect the spring (16) to the engine governor arm (Figure 14-8, Page 14-11) .
4. Install cable (7) in accelerator cable bracket (17) and push down to snap into bracket slot to secure.
5. Confirm that the engine RPM adjustment is correct. See Engine RPM Adjustment on page 14-10.
6. Install the electrical component box cover, and tighten the retaining screw to 18 in-lb (2.0 N·m).
7. Install the air intake hose onto the carburetor.
8. Connect battery and spark plug wire(s). See Connecting The Battery on page 1-3.
CLOSED THROTTLE OR IDLE ADJUSTMENT
1. With the engine running and the Forward/Reverse handle in the NEUTRAL position, attach a tachometer
(CC P/N 1016112) to the spark plug wire and adjust the low idle screw on the carburetor until the tachom-
eter reads 1200 to 1250 RPM
(Figure 14-7, Page 14-9) .
Figure 14-7 Idle Screw
IDLE
SCREW