ELECTRICAL COMPONENTS: FE400, KEY-START ENGINE
Key Switch
Page 12-24
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
12
5. Replace the electrical component box cover (6) and screw (5) and tighten the screw to 18 in-lb (2.0 N·m).
6. Connect the intake hose to the carburetor and secure the hose with the hose clamp.
7. Connect battery and spark plug wire(s).
See Connecting The Battery on page 1-3.
KEY SWITCH
See General Warning, Section 1, Page 1-1.
Testing the Key Switch
See Test Procedure 4, Section 11, Page 11-15. Also see Test Procedure 17 – Key Switch (Engine Kill
Circuit) on page 11-30.
Key Switch Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL posi-
tion. Chock the wheels.
2. Disconnect battery and spark plug wire(s).
See Disconnecting The Battery on page 1-3.
3. Remove the dash panel.
3.1. Loosen seven Tuflok screws, but do not remove screws completely, as shown in Detail A
3.2. Remove Tuflok screws from dash panel as shown in Detail B.
3.3. Pull forward on top of dash panel to access back side of key switch.
3.4. Disconnect the wire connector from the key switch.
4. Remove the key switch.
4.1. Remove the key switch nut (1)
4.2. Remove key switch (2) from back side of dash panel.
Key Switch Installation
1. Install the key switch in the dash in reverse order of removal. Tighten the key switch nut firmly.
Reconnect the wire connector to the key switch.
2. Install the dash in reverse order of removal.
See Key Switch Removal on page 12-24.
3. Connect battery and spark plug wire(s).
See Connecting The Battery on page 1-3.
Figure 12-32 Key Switch Removal
1
2
Summary of Contents for CARRYALL 272
