Club Car CARRYALL 272, Maintenance And Service Manual

Page: 174 / 312

ELECTRICAL COMPONENTS: FE400, KEY-START ENGINE Starter/Generator (Model G425419)
Page 12-4 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
12
cover. The springs will help prevent them from sliding back towards the center (Figure 12-6,
Page 12-4) .
2. Remove nut (41), lockwasher (40), pulley (39), shaft key (34), spacer (37) and bearing retainer screws
(43) and separate armature (33) from output end cover (36) (Figure 12-7, Page 12-4) .
Bearing Cleaning and Inspection
1. Wipe the carbon dust from the two bearings. Inspect bearings by spinning them by hand and checking
for both axial (A) and radial (B) play (Figure 12-8, Page 12-5) .
2. Replace the bearing if it is noisy, does not spin smoothly or has excessive play. Replace if rusted, worn,
cracked, or if there is an abnormal color change in the metal of the bearing. Replace if there is extensive
wear or pitting on the balls or rolling surfaces. Do not remove bearings unless they are to be replaced.
Figure 12-6 Pull Brushes Away From Center of the Commutator End Cover
Figure 12-7 Armature and Output End Cover Assembly
BRUSH BEING HELD
BY BRUSH SPRING
33
34
41
40
39
35
32
TYPICAL
3 PLACES
37
43
36