Club Car CARRYALL 252 2007, Maintenance And Service Manual

Page: 55 / 536

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group Adjustment – Gasoline Vehicles
5
3.8. Check for proper brake operation prior to driving the vehicle.
1
2
1. 1/2-Inch Socket
2. 1/2-Inch Wrench
Figure 5-15 Brake Rod Adjustment Figure 5-16 Accelerator Pedal Height Adjustment
4. Adjust accelerator pedal height.
4.1. Loosen the nut and bolt (Figure 5-16, Page 5-13) securing the accelerator pedal to the pivot plate. Clamp
the accelerator pedal adjustment tool (CCI P/N 101871001) to the accelerator pedal, with the end marked
accelerator pedal height closest to the floorboard. Press the accelerator pedal until the end of the tool rests
against the floorboard; pedal height should be 5-5/8 inches (14.3 cm). Use a rubber strap to hold pedal in
position against the floorboard and then tighten nut to 26 ft-lb (35.3 N·m)
(Figure 5-17, Page 5-13) .
000
000
000
0
ST
OP
PARK
GO
0
GO
0
ST
OP
PARK
MICRO BR
EAK POINT
MICRO BR
EAK POINT
1
2
1. Accelerator Pedal Adjustment Tool (CCI P/N 101871001)
2. Rubber Strap
Figure 5-17 Accelerator Pedal Height Adjustment
5. Adjust the accelerator rod. See following DANGER.
DANGER
• Before servicing, turn the key switch to the OFF position and place the Forward/Reverse handle in
the NEUTRAL position.
• To prevent accidentally starting the vehicle, disconnect the battery cables. See Disconnecting the
Battery – Gasoline Vehicles, Section 1, Page 1-3. This will prevent the possibility of the vehicle running
over you when you are adjusting the accelerator rod.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual Page 5-13