Club Car CARRYALL 252 2007, Maintenance And Service Manual, Page: 363 / 536

UNITIZED TRANSAXLE: DASH-MOUNTED
SHIFTER Axle Shaft
20
CAUTION
• Do not tighten the bearing puller wedge attachment against the axle shaft. This could damage the axle
shaft when pressing the bearing and collar off.
2. Press the bearing (71) and collar (73) off together (Figure 20-7, Page 20-5) . See also Figure 20-8, Page 20-7.
See following NOTE.
NOTE: It may be necessary to heat the collar to remove it.
Do not remove the large axle retaining ring (70) from the axle (Figure 20-7, Page 20-5) . Since the inner
diameter of the retaining ring (70) is smaller than the outer diameter of the bearing (71), the ring must be
in place on the axle before a new bearing and collar are pressed on.
74
73
70
71
74
73
70
68
76
75
67
70
71
73
74
72
71
72
557
Figure 20-7 Differential Gear Case and Axle Tubes
Axle Bearing Installation
1. Ensure that the retaining ring (70) is loosely placed on the axle shaft. See preceding NOTE.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual Page 20-5