Club Car Carryall 1500 2016, Maintenance And Service Manual

Page: 282 / 436

15
Exhaust System
GASOLINE ENGINE, MUFFLER, FUEL
SYSTEM, AND CLUTCHES
NOTE: Make sure the outlet port on the engine is connected to the inlet port on the oil filter and the outlet port of the
oil filter is connected to the inlet port on the engine.
Use new clamps when the hoses are replaced.
3. Fill the engine with engine oil. See Engine Oil on page 10-10.
EXHAUST SYSTEM
MUFFLER REMOVAL
1. Disconnect battery and spark plug wire(s). See Side-Post Battery: Disconnecting the Battery –
Gasoline/Diesel Vehicles on page 1-3.
See Top-Post Battery: Disconnecting the Battery- Gasoline/Diesel Vehicles on page 1-4.
2. Loosen the muffler spring suspension bracket bolts.
3. Remove the two springs that secure the muffler inlet to the intermediate pipe (Figure 15-4, Page 15-6) . See
following NOTE.
NOTE: Shift the end of the muffler inlet and intermediate pipe from side to side to relax and disconnect the springs.
4. Remove the two bolts and large flat washers that secure the muffler to the chassis and remove the muffler.
See following WARNING and NOTE.
WARNING
• Always wear eye protection when springs are removed or installed.
NOTE: Replace springs that show signs of brittleness, broken coils, or loss of tension.
2150
Figure 15-4 Muffler Bracket and Inlet Pipe
Page 15-6 2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual