ACCELERATOR AND BRAKE PEDAL GROUP
Pedal Group Disassembly and Assembly
2000 Turf/Carryall Vehicle Maintenance and Service Manual Page 5-17
5
Park Brake Installation, Continued:
4. Install the push nut (32) on the park brake pedal shaft
5. Connect park brake rod (17) with ball joint (21) to the ball stud on the park brake pedal assembly
.
ACCELERATOR PEDAL REMOVAL
Electric Turf 1, Carryall 1 and all Gasoline Vehicles
1. Make sure key switch is off and that the Forward/Reverse Switch is in NEUTRAL, then disconnect bat-
tery(ies).
See following WARNING.
2. Place chocks under the rear wheels and lift the front end of the vehicle with a chain hoist or floor jack.
Place jack stands under the front cross tube of the vehicle frame and lower the vehicle onto the jack
stands.
See following WARNING.
Figure 5-25 Brake Pedal Weldment Through Floor
Figure 5-26 Park Brake Assembly
Figure 5-27 Attach Torsion Spring
•
ON GASOLINE VEHICLES, DISCONNECT BOTH BATTERY LEADS, NEGATIVE FIRST.
•
ON POWERDRIVE VEHICLES, DISCONNECT BATTERIES AS SHOWN IN FIGURE 1-2, PAGE 1-
3. THEN DISCHARGE THE CONTROLLER AS INSTRUCTED IN THE WARNING ON PAGE 1-3.
STO
P
1
30
32
30
22
23
10
21
12
17
18
19
35
LIFT OTHER END OF SPRING (20) UP AND
OVER BRAKE WELDMENT BY PRYING DOWN
ON SHAFT WITH SMALL SCREWDRIVER
SHAFT
20
HOOK ONE
END OF
SPRING (20)
ON PARK
BRAKE
WELDMENT
WARNING
