www.cls-led.com
www.cls-led.com
- 1 -
- 2 -
CLS Manuals
CLS Miriam
Version 2.0 March 2010
CLS Miriam
CLS Manuals
CLS Atmosphere LED-panel
www.cls-led.com
www.cls-led.com
- 3 -
- 4 -
CLS Manuals
SAFETY INFORMATION
Warning! This product is for professional use only, not for domestic use.
Read this manual before powering up or installing the CLS Miriam. Follow the instructions
listed below and observe all warnings in this manual.
INTRODUCTION
Thank you for selecting the CLS Miriam. The CLS Miriam is an universal luminary that uses 37 Luxeon I LEDs
to create an even light-output. The CLS Miriam can be used indoor and outdoor through its waterproof (IP65)
housing. With these qualities the CLS Miriam is mountable almost everywhere.
NOTE: It is important to read this manual before you install this product.
CLS Miriam
Included items
The CLS Miriam is shipped in one package containing the following items:
• 1 x CLS Miriam
• 1 x user manual
Available Miriam spots
• CLS Miriam RGB fixture, DMX. 37pcs Luxeon-I, medium frosted
(item nr. 140000)
• CLS Miriam RGB fixture, DMX. 37pcs Luxeon-I, narrow clear
(item nr. 140005)
Protection from electric shock
• Disconnect the power supply from AC power before installing, dismounting or maintaining the unit.
• Make sure all connectors are connected properly.
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault protection.
• Refer all service to a qualified technician.
Protection from injury due to falls
• Verify that all covers and mounting hardware is securely fastened.
• Block the access around the work area whenever installing or removing the unit.
Protection from burns and fire
• Do not install the CLS Miriam near a heat source.
• Do not install the CLS Miriam in a corrosive, flammable or explosive area.
• Do not modify the CLS Miriam, or install other than genuine parts.
• Do not operate the CLS Miriam if the ambient temperature exceeds 40º C.
ATTENTION!
ThE CLS MIrIAM IS AN IP65 OuTdOOr uNIT, buT uNdEr
NO CIrCuMSTANCES CAN bE uSEd uNdEr wATEr!
W
ARNING
The CLS Miriam can be installed by using
the mounting hole. Drill a hole to secure it
in the wall, floor, ceiling, etc. Drill a second
hole for the power wire and DMX cables.
Adjust the Miriam to the preferred
position by turning the unit towards
or away from the wall.
Connect the DMX cables to the DMX
controller, then put the power wire in the
earthed socket
The CLS Miriam is ready to use.
270
o
OFF
FCN
CH
%
1
2
3
4
5
6
270
o
OFF
FCN
CH
%
1
2
3
4
5
6
INSTALLATION
This section shows how to install the CLS Miriam.
Optional accessories
• 140010
CLS Miriam Barndoor
• 140025 CLS Miriam RGB extension cable IP65 5 mtrs
• 140027 CLS Miriam RGB extension cable IP65 10 mtrs
• 140030 CLS Miriam RGB connection cable XLR3-connector 5mtr
• 140040 CLS Miriam RGB DMX cable outdoor
• 140050 CLS Miriam RGB connector set male/female IP65
• 707028 CLS Zense DMX cont built in 4 amp RGB dimmer
• 707030
CLS ACX60 DMX controller for max. 60 channels
