CXL-50T Installation Guide v1.0
3
4. Fit the transformer with the fixing screw through its central core. The top of
the transformer has a threaded M6 insert; tighten the screw from underneath using
a hex key.
FRONT PANEL
MEDIA
PLAYER PCB
FRONT PANEL
CONTROLS PCB
MAINS
TRANSFORMER
CXL-50T OUTPUT
TRANSFORMER
MAIN PCB
CN15A
CN15B
100/70/50 V-LINE OUTPUT
CONNECTOR PCB
Red/Brown/
Blue/Black
White/Black
5. The primary winding of the transformer is terminated in a two-pin Molex-type
connector. This should be plugged into the header marked CN15B on the main
PCB. See diagram on page 4 for location.
6. On the rear panel, remove the plastic blanking plate covering the LINE
OUTPUT connector hole.
7. Fit the 4-pin connector on the ends of the secondary winding leads from the
transformer (the remaining four) into this hole, so that the threaded holes in the
two PCB mounting brackets line up with the two holes alongside the connector.
Use the male ends of the hex pillars (supplied) to secure the PCB and connector in
place.
8. Use the two cable ties supplied to tidy up the transformer leads; ensure that
they do not pass over the top of the main heat sink.
9. Replace the top cover, using the original screws.
10. Connect the speaker system to the line outputs using the mating connector.
Note that only two of the pins will be used; one will always be pin 1 (0 V).
