CS-C Series Installation Guide v2.4
3
INSTALLATION
Step 1
Remove speaker from box.
Step 2
Mark and cut hole in ceiling or ceiling tile.
Use included hole template.
CS-C3: 140 mm (5.50")
CS-C4: 177 mm (6.88")
All other models:
271 mm (10.67")
Step 3
Locate euroblock in accessory bag and connect signal wire.
For daisy-chaining use “LINK” output to run to next speaker.
Step 4
Remove grille and set tap switch to proper setting and attach
grille leash to baffle by placing the large end of the clip over
the snap fit post (1) then sliding the clip until small end snaps
into place. Tap switch is preset to highest 100 V position.
1
2
Step 5 (Ceiling Tile Only)
Place tile bridge on back of ceiling tile. Align holes and insert
speaker in hole. Tighten dog ears. Do not overtighten.
(Tile bridge not available for C4.)
Step 6
Insert euroblock into rear of back can. Attach safety restraint
to rear of back can. Close and secure cover plate.
