Cloos NexT 452 AC, Operating Instructions Manual

Page: 45 / 234

45
5.8 Start manually
This function triggers a manual start command.
In the lower part of the display, the Hold value is shown for approx. 10 s
(yellow points). This function is only active as long as the button is pressed.
5.9 Off / Re-start
These functions switch off or restart the welding power source. Select the
desired function with the middle rotary knob. Press and hold the rotary
knob to use the function.
6. MAIN - Programming
The welding power source always uses the existing synergic characteristic
curves. The values for all secondary parameters, including "CleanStart", are
already preset in the synergy characteristic curves.
Activate the "Programming" function to enter the programming mode. In
this menu the default values can be adjusted.
The correction is only an offset which is added to the characteristic curves.
The original characteristic curve is not changed. It can always be reset to
the original state (display "- 0 -").
In programming mode, the following display concept applies:
Yellow
= time
Green = m/min, step size
Red = power
In the programming mode, you can access the next or previous parameter
by shortly tapping on the arrow buttons. A graphic display is integrated for
better orientation.
Above the graphic display the current parameter, the correction factor and
the absolute numerical value with the corresponding physical dimensions
are displayed. Depending on the selected parameter, the display may differ
from the example shown in Figure 11.
The correction value is entered by means of the rotary knob 3. The changed
parameters are saved simultaneously and do not have to be saved addi-
tionally.
F U N K T I O N E N
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Clean
Start
Air
F U N K T I O N E N
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Clean
Start
Air Air
Off Re-start
Programmieren
Impuls-
sync.
Stell-
bereich
Tandem
Schweiß-
kreis
Expert-
Mode
Aktiver
QWD
V
0
A
0.0
P R O G R A M M I E R E N
Startleistung
Dyn.
6.0 m/min
- 0 -
6
2
Puls 4 -Takt
1.2 mm Fe
82% Argon 18% Co
2
Figure 11. "Programming" menu