6
z
When the charger is connected properly, the LED indicator will show a solid red light. (With
power on, the headset will turn off while connected to the charger.)
z
The button stops working while the device is charging.
z
2 hours of charging time is estimated to charge the headset fully.
z
When charging is completed, the LED indicator will turn off.
!note: Do not use other chargers except the approved charger. Using other brand charger will cause
a malfunction or damage of the device.
[Low battery]
If the headset’s rechargeable battery is less than 5% out of full charging, the red light on The LED
indicator will flash and a short tone will sound.
z
Battery charging is needed in above case.
z
When the battery is not charged, the LED indicator will flash red and then turn off.
[Turning on]
z
To turn the headset on, press and hold the multifunction button for 2 seconds.
z
Short and high-pitched tones will sound, and then the blue light on LED will flash fast 5 times.
[Turning off]
z
To turn the headset off, press and hold the multifunction button for 5 seconds.
z
Short and low-pitched tone will sound, and then the blue light will flash 5 times. When it stops
flashing, the headset turns off.
Paring
Paring is the process of associating Bluetooth devices with each other. When two devices are
paired, they establish a permanent, secure link with each other, enabling quick access to services
provided without having to enter passwords every time either device is activated.
Paired devices remain paired even when one of the devices is not powered up, the service
connection is stopped or interrupted, or one or both of the devices are rebooted.
[Initial Paring]
When you connect the HCM-100 with Bluetooth-enabled mobile phone, you need to go through the
paring process. Follow the below instruction for paring.
z
With the HCM-100 off, press and hold the multifunction button for 5 seconds.
z
Two short and high-pitched tones will sound with the LED indicator flickering in red and blue
alternately when the device enters into the pairing mode.
z
Find the Bluetooth Menu from the Bluetooth-enabled mobile phone and "search for" or "add” a
new device.
z
Select the ”Clipcomm HCM-100” from the list of devices.
z
Enter “0000” (4 zeros, the default PIN of the headset) on the mobile phone when it requests a
password.
