Climax VM1700S, Operating Manual, Page: 52 / 94

Page 40 VM1700S-1900S Operating Manual
5.4.2 Pneumatic equipment tasks
CAUTION
All work on the machine’s pneumatic equipment must be carried
out by trained pneumatic specialists!
Before any service and maintenance work, the pressure has to be released.
Disconnection of lines under pressure should only be done with adequate tooling
and according to all safety regulations that apply.
All hoses should be changed according to the preventative maintenance regula-
tions even if there are no visible damages (observe the manufacturer’s recommen-
dations).
Before start-up and service or maintenance work:
• Check that all bolt connections for tightness
• Check that all covers, filters etc. are in place
After service and maintenance work and before putting the machine into operation
again, check that:
• All objects and other material, which are/is not required for operation
of the machine must be removed from the machine’s operating area.
• All liquids that might appear are removed
• All safety devices of the machine are properly working.
5.5 T
ROUBLESHOOTING
If the machine cannot be started or if there are any malfunctions during operation,
the operator must inform qualified maintenance personnel immediately.
CAUTION
The operator must inform the supervisor and should never try to
resolve any problem on the electrical equipment on their own.
To avoid any danger to life and health of person due to electrical
short circuit: All work on the machine’s electrical equipment must
be carried out by trained electrical specialists only. The operator
may only resolve faults resulting from wrong operation or lag of
maintenance.
During all work on the machine, the electrical power supply line
must be disconnected to avoid any danger to the life and health
of people due to uncontrolled rotation of machine spindle.