Climax Coffee Grinder
Made In Melbourne Australia For Over 65 Years
This machine is fitted with an automatic thermo trip which will cut off power to the motor if the
motor overheats. (E.g. A hard body such as a stone preventing the cutters from turning) As the
thermo trip will reset after about 20 seconds and the machine will turn on. To avoid burning out the
motor please switch machine off at the on/off switch or on the wall outlet, then remove the
obstruction.
3. Care / Maintenance / Adjustment
-
Care and Cleaning of coffee Grinder
The coffee grinder should be cleaned at least once a week and always if soiled.
Only clean the coffee grinder with a dry cloth.
Do not
use an alkaline cleaning agent
Do not
spray the coffee grinder with water and/or steam.
Using these can result in a short circuit of the machine risking permanent damage. The use of an
alkaline cleaning agent can also alter the taste of the coffee.
-
Maintenance
If the quality of the grinder is no longer at the required standard, the grinding burrs
must be replaced.
The burrs should also be inspected for wear annually.
Don’t attempt to inspect the quality of the grinding disks by yourself. Always get a competent
specialist and/or service personnel to do it for you.
-
Grinder calibration
Calibration of the grinder (with the setting nut) makes the fineness of the ground
coffee correspond with the fineness set on the scale (marked)
Calibration of the grinder must only be performed by persons familiar with the unit after carefully
reading the following instructions.
-
Basic calibrations should be made after replacing the grinding burrs, following
inadvertent displacement of the basic calibration.
