2
&
&
4 continuous beeps will sound indicating the user that he has entered invalid keystroke, and the user is
asked to repeat the process again.
z
z
P
P
o
o
w
w
e
e
r
r
:
:
z
The Keypad uses a CR2450 3V 540mAH lithium battery as its power source. It has a typical battery life of
over
7
years at an average of 4 activations a day.
z
The Keypad can also detect the battery status. Low battery detection operates where the Keypad has
enough reserve energy to typically operate for 4 month before complete exhaustion.
z
When the Keypad has low battery, the
Orange
F
F
a
a
u
u
l
l
t
t LED will flash during operation and a low battery signal
will be transmitted along with regular signal transmissions.
z
Before shipment, the battery is pre-installed by the factory.
z
z
P
P
o
o
w
w
e
e
r
r
S
S
a
a
v
v
i
i
n
n
g
g
F
F
e
e
a
a
t
t
u
u
r
r
e
e
:
:
z
When the Keypad is not being used, no power is consumed. Whenever a key is pressed, the Keypad will
activate and “
wake-up
” for 5 seconds when any key is pressed.
z
After 5 seconds of key inactivity, the power turns off again and returns to Stand-by mode.
z
Upon completion of a command input, the power turns off and returns to Stand-by mode.
z
z
T
T
e
e
s
s
t
t
m
m
o
o
d
d
e
e
:
:
z
Keypad can be put into Test mode by entering the PIN code (default:
0000
) followed by
＊
. The Green
Active LED will flash and Keypad sounds a long beep.
z
To exit Test mode, press
twice
, Keypad will sound a long beep and the Green Active LED will turn on,
then Keypad returns to Normal Operation mode.
<
<
N
N
O
O
T
T
E
E
>
>
&
&
When Keypad is in Test mode, it operates as
wake-up
condition thus will NOT disconnect after 5 seconds.
&
&
In Test Mode, if no key is pressed within 30 minutes, the Keypadl will automatically exit Test Mode to
Normal Operation mode.
The Keypad Test mode enables the following functions:
Transmit Keypad learn signal — press
＊
and then
1
Dual-key Panic Alarm Enable — press
＊
and then
2
Dual-key Fire Alarm Enable — press
＊
and then
3
Dual-key Medical Alarm Enable — press
＊
and then
4
Change the Pin Code — press
＊
and then
6
Enter Old Pin Code and then press
Χ
Enter New 4-digit Pin Code and then press
#
Dual Key Disable — Press
＊
and then
5
Quit Test Mode —press
twice
.
Arm/ Home without PIN Code — press
＊
and then
8
Arm/ Home with PIN Code — press
＊
and then
9
<
<
N
N
O
O
T
T
E
E
>
>
&
&
For wrong entering or operating the Keypad will sound 4 short beeps
.
&
&
When the Pin Code is wrong entered for 4 times, the Keypad will sound 4 beeps and all LED flash 4 times.
The Keypad will be locked for 1 min. After 1 minute, the Keypad will sound one beep and can be used
again.
