Climax KM4000, Operating Manual, Page: 25 / 78

P/N: 16328, Rev. 7 Page 15
Operation
CAUTION
Always wear eye and ear protection when
operating the key mill.
Connect the key mill by following the procedure outlined below.
Electric Power Connection
WARNING
The electric motor is not watertight. To avoid
injury by shock or explosion, do not operate
electric motors in damp or volatile conditions.
1. Turn off the motor.
2. Check the power cord for damage. Repair or replace the cord if necessary.
3. Connect machine power unit to speed controller. Make sure speed control on/off switch is set to
OFF.
WARNING
To avoid serious bodily injury from moving
machinery, turn speed control power switch to
OFF before connecting it to the power source.
4. Connect speed controller to the power source. Set motor on/off switch to ON. Apply power by
switching speed controller ON.
CAUTION
Do NOT use on/off switch on motor when speed
control is connected. Controller damage may
result and any applicable warranty may be
voided.
5. Position the end mill on the shaft.
Air Power Connection
WARNING
Securely mount the key mill to the work piece
before connecting the air supply.
The air filter and lubricator supplied with the machine must be used or the machine warranty is void.
Set the lubricator to deliver oil at a rate of 20-30 drops per minute at full throttle.