Climax H&S TOOL SPEED FACER ODF100, Operating Manual

Page: 54 / 132

Page 36 ODF Speed Facer Operating Manual
4. If using 0.50” (12.7mm) square tooling install
the 0.50” tooling adapter against the top of the
swivel tool post slot. The channel in the tooling
adapter accepts the 0.50” square cutting tool.
F
IGURE
3-10. .50”
TOOL ADAPTER INSTALLED
(P/N 89175)
5. Set the tool to the desired cutting depth.
T
IP
:
Always insert the cutting tool as far as
possible into the tool holder for stability.
3.4.5 Installing the offset tool holder
The offset tool holder is reversible to allow additional
clearance on both OD and ID operations.
T
IP
:
The offset tool holder is supplied with the
backfacing attachment.
Do the following to install the offset tool holder onto
the swivel tool post:
1. Remove any tool that may be installed in the
swivel tool holder.
2. Slide the offset tool holder onto the swivel tool
post.
3. Insert the bar tool clamp in the slot of the
swivel tool holder in place of tooling.
4. Adjust the angle and position of the offset tool
holder for the process.
5. Tighten the M20 tool clamp screw to secure.
6. The cutting tool can now be installed in the off-
set tool holder with the cutting edge facing the
rotation direction of the machine. Secure with
the four fasteners.
F
IGURE
3-11. O
FFSET TOOL HOLDER
(P/N 89203)
7. To reverse the position of the offset tool holder,
do the following:
a) Loosen the M20 tool holder screw.
b) Rotate the tool holder approximately
180°.
c) Tighten the M20 tool holder screw.
d) Remove and flip the cutting tool with the
cutting edge facing the rotational direc-
tion of the machine.
3.4.6 Rotating the tool head
Do the following to rotate the tool head:
1. Loosen the two swivel clamping screws to free
the circular clamp collar on the back of the tool
head.
CAUTION
Do not loosen the tool head rapidly. Keep your hand
on the tool head for stability. Quick disengagement
of the tool head can cause it to swing unexpectedly,
and may result in personnel injury or machine
damage.
2. Position the tool head.
3. Secure the clamp collar by tightening the two
swivel clamping screws.