Climax H&S TOOL SPEED FACER ODF100 Operating Manual Download Page 20

Page: 20 / 132

Page 2

ODF Speed Facer Operating Manual

Observe the following safety precautions when operat-
ing or working around the machine.

Training –

Before operating this or any machine

tool, you should receive instruction from a qual-
ified trainer. Contact H&S for machine-specific
training information.

Risk assessment –

Working with and around this

machine poses risks to your safety. You, the end
user, are responsible for conducting a risk
assessment of each job site before setting up
and operating this machine.

Intended use –

Use this machine in accordance with

the instructions and precautions in this manual.
Do not use this machine for any purpose other
than its intended use as described in this man-
ual.

Personal protective equipment –

Always wear

appropriate personal protective gear when
operating this or any other machine tool.
Flame-resistant clothing with long sleeves and
legs is recommended when operating the
machine. Hot chips from the workpiece may
burn or cut bare skin.

Work area –

Keep the work area around the

machine clear of clutter. Restrain cords and
hoses connected to the machine. Keep other
cords and hoses away from the work area.

Lifting –

Many H&S machine components are very

heavy. Whenever possible, lift the machine or
its components using proper hoisting equipment
and rigging. Always use designated lifting points
on the machine. Follow lifting instructions in
the setup procedures of this manual.

Lock-out/tag-out –

Lock-out and tag-out the

machine before performing maintenance.

Moving parts –

H&S machines have numerous

exposed moving parts and interfaces that can
cause severe impact, pinching, cutting, and
other injuries. Except for stationary operating
controls, avoid contact with moving parts by
hands or tools during machine operation.
Remove gloves and secure hair, clothing, jew-
elry, and pocket items to prevent them from
becoming entangled in moving parts.

Sharp edges –

Cutting tools and workpieces have

sharp edges that can easily cut skin. Wear pro-
tective gloves and exercise caution when han-
dling a cutting tool or workpiece.

Hot surfaces –

During operation, motors, pumps,

HPUs, and cutting tools can generate enough
heat to cause severe burns. Pay attention to hot
surface labels, and avoid contact with bare skin
until the machine has cooled.

1.4

ACHINE

SPECIFIC

SAFETY

PRECAUTIONS

Eye hazard –

This machine produces metal chips

during operation. Always wear eye protection
when operating the machine.

Hazardous environments –

Do not operate the

machine in environments where potentially
explosive materials, toxic chemicals, or radia-
tion may be present.

Sound level –

This machine produces potentially

harmful sound levels. Hearing protection is
required when operating this machine or work-
ing around it. During testing, the machine pro-
duced the sound levels

listed in Table 1-1.

Machine sound testing was conducted in accordance with Euro-

pean Harmonized Standards EN ISO 3744:2010 and EN 11201:2010.

ABLE

1-1. S

OUND

LEVELS

S Pneumatic Motor

Sound power

102.3 dBA

Operator sound pressure

87.6 dBA