Climax FF7200, Operating Manual

Page: 56 / 146

Page 48 FF7200 Operating Manual
Quick setup
Milling attachment setup
1. Install the milling head assembly to the machine.
2. Install the machine into the workpiece (Hydraulic/Hydraulic
machines must be operated using a dual pump 25hp HPU).
3. Attach all hoses.
4. Adjust the drag brake as necessary. The drag brake should be
adjusted so that the machine does not rotate under load. This is
done by tightening the two bolts that press down on the cylinder.
CAUTION
Before operation, make sure all guards are in place and
all fasteners are tight.
Tool setup
The milling head has four tramming
screws adjacent to the mounting screws
of the housing. This allows the milling
head to be jacked away from the adapter
plate to tram the vertical orientation of the
spindle. Two additional screws are on top
of the plate to adjust the tilt of the milling
head.
Since the milling head is mounted on a
center pivot, the angle of the milling head
must be aligned before machining can
begin. This adjustment is made using the
adjustment screws in the blocks mounted
either below or above the housing. The
rotational adjustment screws allow the
housing to be rotated slightly to achieve
vertical or horizontal orientation relative to
the turning arm.
Do the following to adjust the milling head
and spindle:
1. Loosen the lock.
2. Adjust the milling head and
spindle.
3. Use the DRO to position the milling
head.
4. Tighten the lock before machining.
Figure 31. Drag brake
Figure 32. Milling head components (P/N 72277)