Climax FF6300, Operating Manual

Page: 73 / 132

P/N 80679, Rev. 10 Page 57
4 OPERATION
IN THIS CHAPTER:
4.1 P
RINCIPLES OF OPERATION
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -57
4.2 P
RE
-
START CHECKS
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -57
4.3 M
ACHINING
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -59
4.3.1 P
NEUMATIC
-
POWERED MACHINING
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -59
4.3.2 H
YDRAULIC
-
POWERED MACHINING
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -59
4.3.3 A
DJUSTING THE MACHINE WHEN THE CUT IS COMPLETED
- - - - - - - - - - - - - - - - - - - - -61
4.4 D
ISASSEMBLY
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -61
4.1 P
RINCIPLES OF OPERATION
Do not operate this machine without adequate training to fully understand safe setup,
operation, and maintenance.
CAUTION
To avoid serious personal injury, keep clear of moving machinery during
operation. Always be aware of the location of all personnel near the
machine.
The FF6300 often is used in dangerous locations (in elevated positions, near other
operating equipment, overhead, etc.). CLIMAX cannot foresee where this machine
will be used; therefore, you must perform a site-specific risk assessment (Section 1.5
on page 6) for each job before starting work.
The FF6300 machine has remote operation features that enable you to choose the
optimum location to work from.
WARNING
Always follow safe work practices, including site-specific safety
requirements. It is your responsibility to perform a risk assessment before
you set up the machine and each time before you operate the machine.
4.2 P
RE
-
START CHECKS
WARNING
Rotating machinery can cause serious injuries. Turn off and lock out the
machine before making the pre-start checks.