2
CP-23 features auto low battery detection. When battery voltage is low, CP-23 will send a
low battery signal to notify the Control Panel of its status. Its red LED will show 3 flashes
every 3 minutes until the battery is replaced.
If CP-23 is in the low battery status, when you press the Active Button to dial an
emergency call or alarm, the green and red LEDs will be turned on. CP-23 will emit
continuous beeps until two-way communication is opened. The green and red LEDs flash
during the two-way communciation.
<
<
N
N
O
O
T
T
E
E
>
>
It is prohibited to learn-in the CP-23 to the Control Panel when the CP-23 is in low
battery status.
To replace the battery
:
1.
Open the back cover.
2.
Remove the old batteries and press the Active Button several times to fully discharge.
3.
Put a new batteries into the battery compartment.
4.
Replace the back cover.
III.
Learn In CP-23
For Medical Panels CTC-1052RV and CTC-1041RV:
Each CP-23 comes with a unique numeric code called “
ID code
”. The ID code enables the
Control Panel to identify the signal is transmitted from a particular CP-23. It at the same time
prevents interference from outside sources.
Step 1. Please refer to the Control Panel manual and put the Control Panel into
Learning
Mode
.
Step 2. Press and hold the CP-23 button for 8 seconds until you hear a long beep. The red
LED of CP-23 is turned on. CP-23 is now in learning mode.
Step 3. Now the LED of CP-23 turns from red to green. The green LED blinks. The Control
Panel will emit two quick beeps. Afterwards CP-23 will emit one beep and its green
LED will be turned on and then go off instantly. CP-23 has been successfully learned
in.
<
<
N
N
O
O
T
T
E
E
>
>
You cannot learn in the same CP-23 twice.
Step 4. Check if CP-23 has been learned in successfully. Press the CP-23 button and you will
hear continuous beeps from CP-23. When CP-23 beeps, the Control Panel will
respond with one long beep to indicate that CP-23 is within the operation range.
Step 5. Exit the Control Panel out of Learning Mode. The Learning process is now complete.
<
<
N
N
O
O
T
T
E
E
>
>
Re-learning is only required if the CP-23 is removed, but not required after battery
replacement. To remove CP-23, you have to remove it from the Control Panel.
For Mobile Pers Base Stations and MX Control Panels:
Step 1. Please refer to the Mobile Pers manual or the MX manual and put the Base
Station/Control Panel in learning mode.
Step 2. Press the green reset button on the Base Station/Control Panel once to learn
