Climax BB8100, Operating Manual Original Instructions, Page: 53 / 112

P/N 57064, Rev. 5 Page 43
DANGER
Failure to properly torque the four 3/4-16 x 2 SHCS (P/N 28757)
to 150 ft-lb (210 Nm) can result in unexpected slippage of the
tool arm which can result in injury or be fatal.
Adjusting the tool carrier for
perpendicularity
The tool carrier is equipped with four set screws
that allow you to adjust the slide arm
perpendicularity if required.
Feedbox assembly
Mount and secure the feedbox with adapter plate
(P/N 54867), as shown in Figure 32.
Install the counterweight arm onto the tool carrier
1. Rotate the tool carrier on the bar to allow the counterweight arm to be
mounted on the receiving surface of the tool carrier.
2. Attach the lifting eye onto counterweight arm and install arm
IMPORTANT
Always use the lifting eyes when lifting the arms.
The rotating lifting eyes provide the flexibility and
safety during setup operations.
3. Using a lifting device such as a crane, lift the counterweight assembly to the
arm. Fasten the counterweight assembly to the arm using the 7/8-14 x 1-1/2
(P/N 53049).
Note that you can position the counterweight itself anywhere along the arm as needed to
balance the assembly.
Figure 32. Facing slide arm with feedbox
and adapter plate