6
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for freezing outdoor conditions. It must not be used in freezing outdoor
conditions.
Remote Control
How to Insert the Batteries in the Remote Control
1. Remove the battery cover by sliding it according to the arrow direction.
2. Insert new batteries, making sure that the (+) and (–) of battery are installed correctly.
3. Reattach the cover by sliding it back into position.
NOTES:
■ Use 2 “AAA” (1.5 volt) alkaline batteries. Do not use rechargeable batteries.
■ Remove the batteries from the remote control if the system is not going to be used for a long time.
■ To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.
■ The remote control signal has a range of up to 20 feet.
■ Make sure nothing is between the air conditioner and the remote that could block the signal.
■ Make sure batteries are fresh and installed correctly as indicated on the remote control.
Cool Mode
Use the Cool mode at Low, Med, High or Auto Fan Speed for cooling. Use the Temperature Increase ▲/ Decrease
▼pads to set the desired temperature between 64°F and 86°F in 1°F increments. An electronic thermostat is used to
maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor
air will become warmer.
Cooling Descriptions
For Normal Cooling
—Select the Cool mode and High or Med fan with a middle set temperature.
For Maximum Cooling
—Select the Cool mode and High fan with a lower set temperature.
For Quieter & Nighttime Cooling
—Select the Cool mode and Low fan with a middle set temperature.
NOTE:
If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool
setting, it may take approximately 3 minutes for the compressor to start and cooling to begin.
Energy Saver Mode
Controls the fan.
ON
—The fan will cycle on and off with the compressor. This results in wider variations of room temperature and humidity.
Normally used when the room is unoccupied.
OFF
—The fan runs all the time, while the compressor cycles on and off.
NOTE:
The fan may continue to run for a short time after the compressor cycles off.
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan speed to provide air circulation and filtering without cooling. Since fan
only settings do not provide cooling, a Set temperature cannot be entered. The room temperature will appear in the
display.
NOTE:
Auto Fan Speed cannot be used when in the Fan Only Mode.
Auto Fan Speed
Set to Auto fan speed for the fan speed to automatically set to the speed needed to provide optimum comfort settings
with the set temperature. If the room needs more cooling, the fan speed will automatically increase. If the room needs
less
cooling, the fan speed will automatically decrease.
NOTE:
Auto Fan Speed cannot be used when in the Fan Only Mode.
Power Outage Recovery Feature
In the case of a power outage or interruption, the unit will automatically re-start in the settings last used after the power is
restored. If the Delay 1–24hr feature was set, it will resume countdown. You may need to set a new time if desired.
OPERATING INSTRUCTIONS
