Fore Aire - 12v/48v Club Car Precedent - Installation Instructions
__ ________
5
Main Mounting Hole
i.
Measure and mark a line 15 1/4
” from the
roof rear
angle as shown. (Figure 4)
ii.
Place Adapter
(C2)
onto the roof as shown and align
the adapter edge with your mark. (Figure 5)
iii.
Using Adapter
(C2)
as a guide, drill a 1/4
” pilot hole
through the roof. Remove Adapter
(C2)
and set aside.
iv.
Flip the roof over and drop the Saw Guide
(H)
center
pin into the pilot hole, being careful to rotate and align
to the roof front and back as indicated on the guide.
(Figure 6)
v.
Once aligned, secure the Saw Guide with screw
(L)
in three places.
vi.
Drill a 1/16” diameter
pilot hole at the Saw
Guide notches in four
places. The drill bit
should fit into the notch
as shown. (Figure 7)
vii.
Remove the Saw Guide and enlarge the four pilot
holes to 3/8” dia. These will be your starter holes for
the saw blade.
Figure 4
Figure 5
Figure 6
Figure 7
