9/11
WATER DRAINAGE
When the unit is in cooling mode, unwanted water is extracted from the air. Most of this water is re-used to
cool the unit and make it run more efficiently. When the unit is used in extremely humid environments, water
will collect in a water container at the bottom of the unit. When the water container is full, the compressor will
stop but the fan will continue to run.
When the water container is full, the unit will display ‘
E2/E4
’ by means of the Water Indicator Full lamp being
illuminated on the control panel until the tank is emptied. To resume operation, empty the water container
according to the following steps:
1. Turn the unit off. Try not move the unit when the water container is full (can cause spillage)
2. Place a drain pan under the drainage port at the back of the unit (perhaps use a shallow tray)
3. Remove the rubber plug from the drain hole & drain water
4. Once the water container has been emptied, replace the rubber plug into the drain hole firmly
NOTE: In heating mode, the unit will also create water which needs emptying from the machine.
Continuous Drainage
You can of course set the unit up for continuous drainage thus negating the need to empty water from the
machine. To do this remove the rubber bung from the unit and attach the drain hose to the unit, then drain
the water into a container (be careful that it doesn’t overspill from the container)
Recommendation
To make it easier to empty the water from the machine we recommend raising the unit from the floor, this will
allow easier access to the drain port and allow easier drainage. We aim to sell a floor mount for the unit
which will allow you to place the unit into the floor mount which will raise the height of the unit and thus raise
the height of the drain port – please see
www.climachill.co.uk
for details.
