ClimaCheck Gateway NX400 Hardware Manual
–
2020-03-26 Page 15 of 41
3.5
Show IP-addresses
To show what IP-addresses the Gateway uses on LAN, WiFi and GPRS connections:
•
Press ESC to enter the Main menu
•
Press Down until “Monitor”
appears in the display
•
Press SEL to enter Monitor menu
•
Press Down until “Show IP
-
addresses”
is showed in the display
•
Press OK
IP-addresses for all network interfaces is presented. To change communication settings, see
section 3.11.
3.6
Show IODevices
To show status and address for all configured Modbus units:
•
Press ESC to enter the Main menu
•
Press Down until “Monitor”
appears in the display
•
Press SEL to enter Monitor menu
•
Press Down until “Show IODevices”
appears in the display
•
Press OK
Device name, Modbus address and status are displayed. Status is OK when communication is
working and Error if the unit can
’
t connect to the IODevice. After a number of failed attempts, the
device is disabled and get Status Disabl. The unit will enable the devices again once every hour to
try to restore communication. The most common devices are listed in Table 4 below, see section
4.6 for more information about configuration of IODevices.
Table 4
Device
Description
IAIO
Internal Analog Input and Output on the Gateway
R560
ClimaCheck R560 analog input module
PScout
Power Scout power meter
1W
Internal 1-Wire module
Figure 8, "Show IODevices" menu
