5. For Garage Door #1: Connect one of the three supplied brown, twin-lead
wires to the two screws under the “1” on the 3-Door Programmable Receiver.
NOTE: Keep all wires away from the garage door and drive mechanism.
6. Attach the other end of the twin-lead wire to the same screws used for the
interior push button control, as shown in diagram 1.
7. If you wish to control a second or even a third garage door with the same
receiver, repeat steps 5 and 6 for garage door opener #2 and #3 using the two
screws noted for opener #2 and #3 on the 3-Door Programmable Receiver.
8. Plug the AC adapter into a wall outlet and plug its connector into the bottom
of the 3-Door Programmable Receiver.
NOTE: Keep the cord away from the garage door and drive mechanism.
9. Reconnect the garage door opener’s power cord.
10.
Attach the supplied whip antenna to the connector on the 3-Door
Programmable Receiver.
2
Summary of Contents for Garage Door Interface
Page 4: ...4 ...
