Clifford 3806X, Owner'S Manual

Page: 29 / 45

26 © 2014 Directed. All rights reserved.
Out of Range
Each time a command is performed the Responder LE will expect a
command confirmation from the system. If a command confirmation
is not received the transmit LED flash and a long fault tone plays as
an alert.
No Remote Output
Occasionally when a command is performed the remote may not
generate a command confirmation output or Out of Range output.
This indicates that the system received the command but it was an
incomplete command (e.g. Aux button pressed too short to activate
the trunk release) or it was an illegal message (e.g. the command was
corrupted due to local RF interference). These are temporal nuances
of the system and remote, perform the command again within 10
seconds to return to normal operation.
Feature not Available
The Feature Not Available output (transmit LED on and long fault tone)
is a generic one which varies in cause and solution depending upon
the command used:
Command Cause Reason/Solution
Sensor Bypass System is not armed Only available when system is armed
Vehicle Recovery System (VRS)
In case your vehicle is stolen or carjacked, VRS sounds the siren and
flashes the parking lights to persuade the thief to abandon the vehicle,
and when the ignition is turned off, activates the starter kill to prevent
the engine from restarting.