30
©
2005
Directed Electronics, Inc.
3. SSeelleecctt tthhee rreecceeiivveerr cchhaannnneell:: Press and release the Valet/Program button the
number of times necessary to access the desired channel.
N
NO
OTTEE:: If adding a remote, a button must be taught to the unit in the Channel 1 or Channel 4 position
prior to programming other channels.
Press and hold the Valet/Program button once more. The siren will chirp and the LED will blink
the number of times corresponding to the channel that is accessed.
4. T
Trraannssm
miitt.. While HOLDING the Valet/Program switch, press the button from
the transmitter that you wish to assign to that channel. The unit will chirp
indicating that the channel has been entered.
5. C
Coonnffiirrm
m.. While still HOLDING the Valet/Program switch, press the same
transmitter button that you just programmed. The unit will chirp twice to
confirm that the desired channel has been successfully programmed to the button.
If this step is not performed, the channel will not be programmed to the button.
It is not possible to teach a transmitter button to the system more than once.
C
Chhaannnneell ##1111:: If any button from a known transmitter is programmed to Channel 11, all trans-
mitters will be erased from memory and the system features will revert to the default settings. This
is useful in cases where one of the customer's transmitters is lost or stolen. This will erase any lost
or stolen transmitters from the system's memory. It can also be used to start from scratch if the
transmitter buttons were programmed incorrectly.
Valet Step
Function
Wire Color
1
Auto/Learn Standard
2
Lock/Arm/Panic On/Panic Off
3
Unlock/Disarm/Panic Off
4
Channel 2
RED/WHITE
5
Channel 3
WHITE/BLUE
6
Channel 4
VIOLET/BLACK
7
Channel 5
WHITE/BLACK
8
Channel 6
GRAY/BLACK
9
Arm/Disarm/Panic
10
Panic Only
11
Delete All Transmitters
*NOTE: For Auto Learn Configurations, see
Transmitter Configurations section of this guide.
