INSTALLATION AND OPERATING INSTRUCTIONS
5
4. Use a towel to remove any excess water from the Pre-filter
5. Allow the Pre-filter to dry for 12-24 hours
6. When the Pre-filter is completely dry, re-attach and place back
into the air purifier. Note: When placing the filters back into the
air purifier, ensure that the white belts are facing outwards and
that the Pre-filters are facing towards the air inlet
CLEANING THE HEPA AND ACTIVATED CARBON FILTER
It is recommended that the HEPA and activated carbon filters are
cleaned every 100-500 hours of unit operation, depending on the
air quality of the room.
To clean the HEPA and Activated Carbon Filter:
1. Turn off unit and disconnect the power
2. Place both hands at the bottom corners of the front cover, and
pull out
3. Pull out the filter by the white belt attached
4. Gently peel away the Pre-filter layer
5. Run a vacuum cleaner with a nozzle or brush attachment on low
power setting along the HEPA (white side) and Activated Carbon
(black side) filters to pick up the dust and various particles.
6. Re-attach the Pre-filter layer and place back into the air purifier.
Note:
When placing the filters back into the air purifier, ensure
that the white belts are facing outwards
REPLACING FILTER
When the lifespan of the 3-layer filter reaches it end, the POWER
light will flash green indicating that it needs to be changed. Discard
the old filter and replace with a new one. It is not reusable.
Cli~Mate Replacement Filter Product Code: CLI-RF-AP20
The lifespan and duration of the dual layer filter depends on the air
quality and surrounding environment. The higher level of pollutants,
the shorter the filter lifespan. It is advisable to change the 3-layer
filter at least every 8 months or 1500 hours of unit operation.
HOW TO REPLACE THE FILTER
1. Turn off unit and disconnect the power.
2. OPEN THE FRONT COVER: Place both hands at the bottom
corner of the front cover, press down the buttons on the sides
while pulling out.
3. REMOVE THE FILTER: Pull out the filter by the white belt
attached and discard
4. INSTALL NEW FILTER: Replace with new filter. Ensure that
the white belt is facing outwards
5. Line up the top of the front cover first and then snap in the
lower part of the front cover. Ensure that the front cover is
firmly intact.
6. Hold down Speed
button on the unit to reset the
filter timer.
